Biomass pellet mill is the equipment used to suppress crude fiber, sawdust, straw particles and other materials, which is suitable for the twigs, straw, bamboo and other materials.
Certification: CE, ISO, SS
Wearing Parts: Molds, roller
Motor Choice: Electric or Diesel
Raw Materials: Sawdust, rice husk, agricultural stalk, straw, peanut shell,sunflower husk,etc.
Application Range: Make fuel pellets for stove, furnace and other heating equipments as well as commercial production.
Biomass pellet mill is the equipment used to suppress crude fiber, sawdust, straw particles and other materials, which is suitable for the twigs, straw, bamboo and other materials. After pressing, the diameter of pellet is 6-12 mm, and the length is 3--10 cm. the finished pellet has good characteristics of easy ignition and pure flame, and it does not produce smoke. In order to reduce the pollution of the environment and relieve the energy shortage situation, the use of coal as fuel has been gradually restricted. With rich resources of waste biomass, biomass pellet production plant will be extremely popular in the market!
Biomass pellet mill has wide raw material sources, produced in wood processing and wood-based panel production of sawdust, wood shavings, bark, sand powder, waste wood, crotches; produce crops after harvest of all kinds of straw; other types of combustion of biomass as raw material, no need to add any adhesive, through the equipment processing, can be made biomass pellet fuel.
It adopts large diameter roller, which can process large volume and long fiber raw materials such as straw, rice husk, sawdust and other materials. The grinding requirements of raw material are not high. In addition, in the pressing of fibrous materials, the raw material water content is within 15%-25% (optimum is at about 18%) can be molded, in most cases, it does not need to dry the raw materials.
When the molding density is constant, with the same power, the application of compression molding technology has higher yield than the application of other compression molding technology.
Due to the difference in working principle, the roller speed of ring die technology is slower than the flat die, so the wear of roller die is relatively slow. In addition, the side working face after abrasion can be turned over to use the other side, which can improve the service life of the mill.
The working gap and pressure between the pressing roller and the pressing die can be adjusted by the horizontal shaft and the wheel frame subtraction pad area, which can decide the forming density of materials. The operation is convenient and time-saving; it not only can produce medium and low density compression molding products, but also can produce high density molding products, so the single machine has multiple functions.